Sony Handycam DCR-PC10, Service Manual

Page: 82 / 181

5-5
1-2. CAMERA SYSTEM ADJUSTMENTS
1-2-1. Adjustment Points When Major Parts Have
Been Replaced
When the CCD imager or lens block is replaced, adjust the items
indicated by
® in the following table.
HALL adjustment
Flange back adjustment
IRIS IN/OUT adjustment
MAX GAIN adjustment
Color reproduction
adjustment
Auto white balance
reference data input
Auto white balance
adjustment
When the CCD
imager is replaced
®
®
®
®
®
®
When the lens
block is replaced
®
®
®
Note: Check that the following adjustment has been completed
before performing “Camera Check Adjustments”.
1. “Initializing the Page D Data” and “Changing the Page
D Data” of “System Control System Adjustments” of
“Video Section Adjustments”.
2. “Base Band Block Adjustment” and “Clock Adjustment”
of “Video System Adjustments” of “Video Section
Adjustments”.
1-2-2. Initialization of Page F data
Note 1: Execute the initialization of page F only when the non-
volatile memory (VC-199 board IC202 EEPROM) is
replaced.
Note 2:
If the page F data has been initialized, all adjustment items
of the camera section must be executed again.
Initializing procedure:
Works required after initialization
Order Page Address Data Procedure
1 Turn OFF and ON the main power supply. (Preparation)
2 6 00 01 Set the data.
3 6 01 2D:NTSC After setting the data, press the PAUSE button.
2F:PAL
4 6 03 01 After setting the data, press the PAUSE button.
5 6 02 Confirm that the data is 01.
Order Page Address Data Procedure
1 6 00 00 Set the data.
2 Turn off the main power supply. (End)
3 Perform the next item “1-2-3. Page F Data Modifications”, then execute all adjustment
items of the camera section.