![background image](http://html.mh-extra.com/html/sony/fst-zux999/fst-zux999_operating-instructions-manual_420541068.webp)
FST-ZUX999.GB.4-148-130-11(1)
GB
Tuner
Severe hum or noise, or stations
cannot be received. (“TUNED” or
“STEREO” flashes on the display.)
Connect the antenna properly.
Find a location and an orientation that
provide good reception, and then set
up the antenna again.
Keep the antennas away from the
speaker cords, the power cord and the
USB cable to avoid picking up noise.
Turn off nearby electrical equipment.
Optional components
There is no sound.
Make sure that respective AUDIO IN
function (AUDIO IN 1 or AUDIO
IN 2) is selected for the connected
optional component.
Refer to General item “There is no
sound.” (page 62) and check the
condition of the system.
Connect the component properly (page
42) while checking:
if the cords are connected properly.
if the cord plugs are firmly inserted
all the way.
Turn on the connected component.
Refer to the operating instructions
supplied with the connected
component and start playing.
Input level of audio source is too high
or too low.
Adjust the input level (page 43).
To change the AM tuning interval
The AM tuning interval is factory-preset
to 9 kHz (or 10 kHz, for some areas).
Use buttons on the unit to change the
AM tuning interval.
1
Tune in any AM station, and then
turn off the system.
2
Press DISPLAY A or B to display the
clock.
3
While holding down ENTER on
CHANNEL A, press
/
.
All the AM preset stations are erased.
To reset the interval to the factory
preset, repeat the procedure.
To reset the system to factory settings
If the system still does not operate
properly, reset the system to factory
settings.
Use buttons on the unit to reset the
system to its factory default settings.
1
Disconnect and reconnect the power
cord, and then turn on the system.
2
Press
on CHANNEL A, ENTER on
CHANNEL B and
/
at the same
time.
All user-configured settings, such as
preset radio stations, timer, and the
clock, are deleted.