Sony DSR-DR1000P, Operating Instructions Manual

Page: 40 / 111

40
Playback
3
Press the PLAY button.
This starts the playback operation. When all data is
played back, the unit stops playback.
To perform the following operations
a) When the SEARCH ENABLE menu item (see page 67) is set to ENABLE.
Recording and Playing Back
Simultaneously
This unit allows you to playback while recording, and to
start and stop recording during playback. You can also
execute recording during search playback
(see page 44)
and program playback (see page 49) .
Note
Program playback may not be seamless during
simultaneous recording and playback.
To play back during recording
This unit is recording if the indicator to the upper left of the
REC button is lit.
Press the P button in the PANEL SELECT section, turning
it on, and follow the steps in
“Playback Procedure” (page
39) .
To start and stop recording during
playback
Press the R button in the PANEL SELECT section,
lighting it, and follow the steps in
“Recording Procedure”
(page 37) to start recording. Press the STOP button to stop
recording.
To set a cue point during simultaneous
recording and playback
Press the SET button with the J (CUE) button held down
at a desired position..
When the R button is lit: A cue point is set at the current
recording position.
When the P button is lit: A cue point is set at the current
playback position.
To select output signals during
simultaneous recording and playback
With each press of the LINE OUT SELECT button, the
indicator light as follows.
R lights > P lights > R and P both light > R lights > P lights
....
Line output signals change as follows, according to the lit
indicators.
R lit: Signals being recorded
P lit: Signals being played back
Switch Setting
75
Ω
termination
switch
ON (or attach a 75
Ω
terminator.)
Input switch Set according to the type of input
signal from this unit.
Operation Do this:
Stop playback. Press the STOP button.
Adjust the audio
playback level. For digital or analog audio output
Set the VARIABLE switch on the front
panel to PB and use the REC/PB
LEVEL control knob for each channel.
For outputs from the PHONES
connector and MONITOR connector
Use the PHONES control knob on the
front panel (outputs from the PHONES
connector on the front panel and the
MONITOR connector on the rear panel
are adjusted).
Do search
playback in shuttle/
jog/variable mode. See “Searching with the search dial” on
page 44 .
Fast forward. See “Searching with the NEXT and
PREV buttons” on page 44 .
Set a cue point Press the SET button with the J (CUE)
button held down at a desired position.
Jump to a cue
point. See “Cueing Up a Desired Cue Point”
on page 46 .
Jump to the start
or end point of a
clip. See “To Search in Clip Units (Clip
Jump)” on page 48 .
Inhibit the SUPER
connector from
outputting text
information (time
data, operation
mode indications,
etc.) to the video
monitor. Set the CHARA. DISPLAY menu item
(see page 68) to OFF.
R button
P button
Time counter display
LINE OUT SELECT
button and indicators