Sony DSR-40, Operating Instructions Manual

Page: 42 / 132

Chapter 3 Using the Unit as a Player in an Editing System
42 GB
Chapter 3 Using the Unit as a Player in an Editing System
4
Perform a trial editing and confirm the adjustment result.
Repeat steps
3
and
4
until best possible result is obtained.
Using this unit as a recorder with FXE-120/120P
• When using this unit as a recorder, also see chapter 4 “Using the Unit as a
Recorder in an Editing System.”
• When using FXE-100/100P that has been upgraded with FXE-KIT1, the
menu item is indicated in [ ].
1
Display the item 102 [112] REMOTE INTERFACE in the SETUP
menu, and set RECORDER to OTHERS.
2
Display the item 104 [301] SYNC GRADE in the SETUP menu, and
set RECORDER to PREROLL & PLAY.
3
Display the item 303 [403] DEVICE TYPE RECORDER in the
SETUP menu, and set the VCR device constants.
4
Execute the LEARN function.
If the edit timing is out of adjustment, follow “Adjusting the IN point”
below.
Adjusting the IN point
If the actual edited point does not accurately coincide with the preset
editing point, perform the fine adjustment of the edit timing using the
SETUP menu of the editing control unit. This improves the editing
accuracy.
1
Display the item 303 [403] DEVICE TYPE RECORDER in the
SETUP menu, and set it from DISABLE to ENABLE.
2
Repeat editing several times and check the shift of the editing point;
that is, count the number of frames to be adjusted.
Note
The editing result may differ between DISABLE and ENABLE
settings of SETUP menu item 303 [403]. Be sure to check the editing
result after changing the setting to ENABLE.
3
Set the SETUP menu item 303 [403] from BYTE 01 to BYTE 10, and
calculate the adjustment value.
Adjusting an Edit Timing