Sony DPS-V77, Operating Instructions Manual

Page: 25 / 92

25
EN
Setting the Noise Gate (Gate)
Use the noise gate function when the source of the input signal
generates a lot of noise. Running the input signal through the noise
gate before processing reduces noise when no sound is being output.
1 Press SYSTEM.
2 Press FUNCTION A “Set Up.”
3 Press FUNCTION B “Gate.”
FUNCTION A [ATK], sets the attack time (the rate at which the
gate opens).
FUNCTION B [REL], sets the release time (the rate at which the
gate closes).
FUNCTION C [THR], sets the threshold level (the level at which
the gate will close). The larger the value, the larger the signal
that will enter the gate.
Cutting the Direct Sound (Dry On/Off)
This setting lets you cut the direct sound and output only the
sound of the effect, regardless of the MIXER block's DRY LEVEL
setting. When using this unit is connected to a mixer in a send/
return loop, as shown on page 12, be sure cut the direct sound.
1 Press SYSTEM.
2
Press FUNCTION A “Set Up.”
3 Press FUNCTION F “Dry On/Off.”
The operation dial selects the dry mode.
OFF : forcibly cuts the direct level (to – ) regardless of the
direct level setting.
PGM : the direct level determined by the value stored in the
mixer block of each effect.
Setting up the Pedal Parameters
Pedals connected to the PEDAL 1 and/or PEDAL 2 jacks on the
rear panel can be used to control the functions listed below.
1 Press SYSTEM.
2 Press FUNCTION C “Pedal.”
3
Press FUNCTION A or B to choose “Pedal 1” or “Pedal 2.”
FUNCTION A [Type] sets the type of pedal function.
MEM +/MEM – : changes memory numbers up/down.
Bank +/Bank – : changes bank numbers up/down.
TBL +/TBL – : changes the table numbers specified in the
pedal program table up/down.
Bypass : sets the pedal to work as the bypass switch
RTC : sets the pedal to control the parameters set in RTC (see
page 21).
FUNCTION B [MIN] lets you input the setting for when the
pedal is in the “up” position (minimum).
FUNCTION C [MAX] lets you input the setting for when the
pedal is in the “down” position (maximum).
FUNCTION D [Curve] lets you select the MIN to MAX
transition curve.
FUNCTION E [TBL#] lets you select the pedal program table
numbers (1–10) when you set FUNCTION A to TBL+/– .
FUNCTION F [MEM#] lets you select the memory bank and
memory number that will respond to the table number set at
FUNCTION E.
Other Settings
To set “Bypass,” see page 15.
To set “Input,” see page 13.
To set the MIDI functions see pages 21 and 26.
To organize the user memory, see page 23.
To set the morphing function, see page 16.