7-24
DVW-790WS/709WS/707
DVW-790WSP/709WSP/707P P2V1
7-16-3. Detail Frequency Adjustment (16:9)
16:9 mode
Note
Perform this adjustment, if necessary, to suit the custom-
er’s preferences.
Preparation
.
On the setup menu, set as follows.
PAGE
: S12
*
FUNCTION 1/2
ITEM
: DETAIL
→
ON
ITEM
: TEST OUT
→
ENC
.
OUTPUT/DCC switch (inside panel)
→
CAM/ON
.
Shoot a grayscale chart (16:9) in the full underscanned
monitor frame.
Equipment
: Waveform monitor
Test point
: TEST OUT connector
Setting point
:
1
Lens IRIS
Spec.
: A = 100
±
2 IRE (NTSC)
A = 700
±
14 mV (PAL)
.
Select the line at the center white portion of the gray-
scale chart.
Adjustment Procedure
Equipment
: Waveform monitor
Test point
: TEST OUT connector
1.
Select the 16:9 mode.
PAGE
: S14
*
WIDE SCREEN
ITEM
: 16:9/4:3 MODE
→
16:9
2.
On the setup menu, adjust as follows.
PAGE
: S16
*
LEVEL 1
ITEM
: DTL FREQ. (Factory setting: 0)
Spec.
: Set the desired width at the edge of
portion B.
Note
After this adjustment, be sure to perform Section 7-16-4
“H/V Ratio Adjustment (16:9)”, and Section 7-16-5
“Detail Level Adjustment (16:9)”, in that order.
7-16-4. H/V Ratio Adjustment (16:9)
16:9 mode
Preparation
.
On the setup menu, set as follows.
PAGE
: S12
*
FUNCTION 1/2
ITEM
: DETAIL
→
ON
ITEM
: TEST OUT
→
ENC
.
OUTPUT/DCC switch (inside panel)
→
CAM/ON
.
Shoot a grayscale chart (16:9) in the full underscanned
monitor frame.
Equipment
: Waveform monitor
Test point
: TEST OUT connector
Setting point
:
1
Lens IRIS
Spec.
: A = 100
±
2 IRE (NTSC)
A = 700
±
14 mV (PAL)
Adjustment Procedure
Equipment
: Black and white monitor
Test point
: TEST OUT connector
1.
Select the 16:9 mode.
PAGE
: S14
*
WIDE SCREEN
ITEM
: 16:9/4:3 MODE
→
16:9
2.
On the setup menu, adjust as follows.
PAGE
: S16
*
LEVEL 1
ITEM
: H/V RATIO
Spec.
: Adjust so that the H and V detail
amounts which are added are equiva-
lent.
A
B
A
H
V
7-16. Detail Signal Adjustment (16:9)