132
Symptom
Cause and/or Corrective Actions
• If you disconnect the power source such as the battery
pack during printing, the platen roller may not move back
to the original position.
c
Install the charged battery pack, set the POWER switch
to VTR or MEMORY and open the LCD panel and the
printer cover.
• The inside of the printer has become too hot.
c
Leave your camcorder until it cools down, then resume
printing images.
• The ribbon has run out.
c
Replace the print cartridge with a new one. (p. 106)
• You have left the printer cartridge in high temperature so
that the ribbon is damaged.
c
Replace the print cartridge with a new one. (p. 106)
• An error has occured during printing.
c
Set the POWER switch to OFF (CHARGE) once, and
then set it to VTR or MEMORY again.
c
Charged the battery, and reinstall it.
• Print paper is not inserted, and the still image to print is
not played back.
c
Insert print paper, and play back the still image to print.
(p. 91, 109)
• If you record the image on “Memory Stick” with other
equipment other than this unit, the printed image may
have a black frame. This is not a malfunction.
Others
Symptom
Cause and/or Corrective Actions
• COMMANDER is set to OFF in the menu settings.
c
Set it to ON. (p. 65)
• Something is blocking the infrared rays.
c
Remove the obstacle.
• The batteries are inserted in the battery holder with the +
– polarities incorrectly matching the + – marks.
c
Insert the batteries with the correct polarity. (p. 151)
• The batteries are dead.
c
Insert new ones. (p. 151)
• DISPLAY is set to V-OUT/LCD in the menu settings.
c
Set it to LCD. (p. 65)
• Moisture condensation has occurred.
c
Remove the cassette and leave your camcorder for at
least 1 hour to acclimatize. (p. 137)
• Some troubles has occurred in your camcorder.
c
Remove the cassette and insert it again, then operate
your camcorder.
• The AC power adaptor is disconnected.
c
Connect it firmly. (p. 15)
• Something is wrong with the battery pack.
c
Contact your Sony dealer or local authorized Sony
service facility.
The Remote Commander supplied
with your camcorder does not work.
The melody or beep sounds for 5
seconds.
The picture from a TV or VCR does
not appear even when your
camcorder is connected to outputs on
the TV or VCR.
While charging the battery pack, no
indicator appears or the indicator
flashes in the display window.
Troubleshooting
The PRINT lamp is flashing fast.
The PRINT CARTRIDGE lamp is
flashing fast.
Printing stops mid may, and the
PRINT PAPER lamp or the PRINT
lamp is flashing fast.
You cannot select 9PIC SAME or
9PIC MULTI in the menu settings.
The printed image has a black
frame.
You cannot insert the print
cartridge.
Summary of Contents for DCR-TRV720
Page 155: ......
Page 156: ...Sony Corporation Printed in Japan ...
