– 8 –
3.
NOTE FOR REPAIR
Make sure that the flat cable and flexible board are not cracked of
bent at the terminal.
Do not insert the cable insufficiently nor crookedly.
When remove a connector, don’t pull at wire of connector.
It is possible that a wire is snapped.
Cut and remove the part of gilt
which comes off at the point.
(Be careful or some pieces of
gilt may be left inside)
When installing a connector, don’t press down at wire of connector.
It is possible that a wire is snapped.
4.
LCD TYPE CHECK
By measuring the resistor value between Pin
6
of CN5502 and
Pin
0
of CN5502 on PD-118 board, the type of LCD can be dis-
criminated.
Note:
About PD-118 board and LCD module, discriminate LCD
type on the machine, and replace the same type.
PD-118 board CN5502
Resistor
LCD type
PD board
value
8.2 k
Ω
TYPE S
PD-118 (TYPE S)
10 k
Ω
TYPE C
PD-118 (TYPE C)
Multi CPC jig
(J-6082-311-A)
CN5502
Volt ohm meter
PD-118 board
6
pin
0
pin