PDW-700/V1 (E)
7-17
7-1-10. Removing/Reinstalling LD Motor
Removal
1.
Remove the outside panel assembly.
(Refer to Section 1-7-1.)
2.
Remove the laser caution sheet.
(Refer to Section 1-6-2 step 2.)
3.
Remove the corner block with adhesive sheet
and cover sheet.
(Refer to Section 7-1-1 step 3.)
4.
Remove the SW guard assembly.
(Refer to Section 1-7-6.)
5.
Remove the loader assembly.
(Refer to Section 7-1-1.)
6.
Remove the drive sub assembly.
(Refer to Section 7-1-2.)
7.
Remove the lock release assembly.
(Refer to Section 7-1-9.)
8.
Disconnect the connector (CN1) on the SW-
1385 board.
9.
Remove the screw
A
and disengage the SW-
1385 board from the claws of the release lock
assembly base.
10. Remove the two screws
B
and remove the
LD motor sub assembly.
Reinstallation
1.
Reinstall the removed parts by reversing
steps 1 to 10.
n
Align the protruded portion of the release
gear with the claw on the release lock
assembly base to install the LD motor sub
assembly.
Screw (B2
x
4) Tightening torque :
15
x
10
_
2
±
0.01 N
.
m {1.5
±
0.1 kgf
.
cm}
CN1
B2
x
4
B2
x
4
B
A
SW-1385 board
LD motor assembly
Release lock
assembly
Claws
B2
x
4
LD motor sub assembly
Release lock assembly base
Claw
Align
Protrude
Release gear
Summary of Contents for CBK-HD01
