Sony Ericsson GM-41 Phase II, Integrator'S Manual

Page: 32 / 51

Confidential
MANUAL 32(51)
Document number Revision
7/198 17-LXE 108 566 Uen A
Note: Any hard copy of this document is for reference only.
Due to template and application dependencies the header and footer may fail to display correct data. It is the
responsibility of the user to ensure that they have a correct and valid version. Any outdated hard copy is invalid and must be removed from possible use.
Group Pin No Name Application Requirements App I/O
19 PCMDLD Logic input from phone module. I
20 PCMULD Logic output to phone module. O
18 PCMSYNC Logic input from phone module. I
PCM
17 PCMCLK Logic input from phone module. I
9 AGND
Analog reference. This signal is an analog reference
output by the phone module. This signal is connected
to GND in one place in the phone module. Under no
circumstances shall it be connected to any ground or
be used as ground in the application.
I
10 ATMS Single ended audio output to phone module. O
Analog
Audio
7 AFMS Single ended audio input from phone module. I
12
MODULE_PWR_
EN_B
Logic open collector output that is set low by the
application to enable power to the phone module. The
pull-up resistor resides in the phone module.
OOC
2 VREF
Phone module logic voltage reference input to
application. This signal provides the application with
the logic system voltage level used by the phone
module. Also used as an application wakeup signal if
used together with RTC.
I
40 RI
This signal is used to indicate to the application of an
incoming call (voice, data, etc.). A falling edge
indicates incoming call. The signal remains low for one
second, then high for three seconds. This is repeated
until call is answered or dropped.
I
24 RINGER
Pulse Modulated logic input from phone module. The
application must provide power amplification if the
current draw is expected to exceed 1mA.
I
Status
15 HW_SD
Bi-directional signal, default set to be an open collector
output from the application. OOC
I
39 CFMS Flash output from phone module. I
Flash
37 CTMS Flash input to phone module O
36 SCL_SPI_CLK No termination. Leave open. IOC
35 SDA_SPI_IN No termination. Leave open. IOC
38 SPI_OUT No termination. Leave open. O
Unused
1 IO_1_TIMEMARK No termination. Leave open. I/O
3 SIMCLK SIM Clock I
11 SIMDET SIM Detect line O
13 SIMRST SIM Reset I
14 SIMVCC SIM Supply voltage I
External
SIM
Interface
16 SIMDATA SIM Data I/O
4 VRTC P
33, 34 VCC_MAIN P
29, 31, 32 VCC_AUX P
Power
5, 6, 8,
21, 22
GND P
Table 26: Pin Direction for General Purpose Signals