SonoSite SiteStand, Service Manual

Page: 15 / 29

Disassembling the SiteStand
SiteStand Service Manual 9
3.3.1 Required Tools
• #1 Phillips screwdriver
• Allen wrench set (5/32-inch, 1/8-inch, and 5/64-inch)
• Slotted screwdriver
• Open end wrench (11/16-inch)
• Round punch (1/4-inch)
3.3.2 Replacing the Sleeve Assembly and the Docking
PCBA
1. Tilt the sleeve assembly to its most upright position.
2.
Use a #1 Philips screwdriver to remove the six screws from the metal base of the
sleeve assembly.
3.
Turn the sleeve assembly over and remove the two screws holding the cable
connector to the sleeve assembly.
4.
Unplug the connectors and set the sleeve assembly aside.
5. Remove the five Phillips screws attaching the PCBA to the sleeve assembly.
3.3.3 Replacing the Power Supply
1.
Lay the SiteStand on a bench with the base facing you.
2.
Use an Allen wrench to remove the four 5/32-inch Allen screws holding the
base.
3. Remove the base and set it aside.
4.
Use an Allen wrench to remove to remove the six 5/32-inch Allen screws and
the 11/16-inch nut on the gas spring securing the subplate.
5. Remove the subplate.
6.
The power supply is visible in the forward section of the SiteStand and is
secured by Velcro. Pull the power supply loose and disconnect the connectors.
7.
To reassemble the SiteStand follow steps 1 through 6 in reverse order.
3.3.4 Replacing the Foot Pedal
Earlier versions of the SiteStand use a pin to hold the foot pedal in place. If the pin
has become loose, you should replace the foot pedal with foot pedal repair kit
(P01321).
1.
Remove the pin using any round punch.
2. Install the foot pedal using the shoulder bolt in place of the pin.
3.
Attach the locking nut and tighten so the nut is secure and that the foot pedal
moves freely.