Chapter 3: Servicing the SiteStand
10
SiteStand Service Manual
3.3.5
Repairing/Replacing the Front Panel Connectors
1.
To access these connectors, use an Allen wrench to remove the six connector
cover 5/64-inch Allen screws.
2.
Extend the gas spring to its maximum height by pressing the foot pedal.
3.
Remove the blade cap by gently prying it up from the sides with a flat blade
prying tool. There are no screws holding it in place.
4.
Use an Allen wrench to remove the eight 5/32-inch Allen screws from the top
subplate.
5.
Left the blade cap and subplate to the top of the shaft and secure it in place.
6.
Gently pull the connector assembly out the top of the blade assembly.
7.
The connector can now be repaired or replaced.
8.
Reassemble the SiteStand by performing steps 1 through 8 (in this section) in
reverse order.
3.3.6
Replacing the SiteStand Fuse
AC power
receptacle
Video output
receptacles
RS-232C
communication
port
Power output
connectors
Black-and-white thermal
printer
Printer remote
control connector
Video output
receptacle
Fuse drawer
Summary of Contents for SiteStand
