![background image](http://html.mh-extra.com/html/somfy/oximo-40-solar-io/oximo-40-solar-io_manual_1317489008.webp)
6
EN
Oximo 40 Solar io
Copyright
©
2021 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
2.3.1. Pre-programming the control point
1) Connect the drive (
see 2.2. Wiring
).
2) Press the
Up
and
Down
buttons on the control point: The
motorised product makes up and down movements (rapidly
raising and lowering) and the control point is pre-programmed in
the drive.
2.3.2. Checking the direction of rotation
1) Press the
Up
button on the control point:
a) If the motorised product rises (a), the direction of rota-
tion is correct: move onto the section entitled
Setting the
end limits
.
b) If the motorised product lowers (b), the direction of ro-
tation is incorrect: Go to the
Modifying the direction of rotation step.
2.3.3. Modifying the direction of rotation
1) Press the
my
button on the control point until the motorised
product moves up and down: the rotational direction has been
modified.
2) Press the
Up
button on the control point to control the
direction of rotation.
2.3.4. Setting the end limits
Automatic setting of the end limits (2.3.4.a)
1) Press the
Up
and
Down
buttons on the control point at the same
time: The motorised product moves up and down (moves up and
down rapidly).
2) Press the
my
button until the motorised product moves up and
down.
Setting the end limits in manual mode (2.3.4.b)
͉
The end limits can be set in any order.
1) Raise the motorised product to the desired upper position by
pressing the
Up
button.
2) Press the
my
and
Down
buttons at the same time until the
motorised product moves.
The upper end limit is memorised.
3) Press the
my
button when the motorised product reaches the
desired lower position. If necessary, adjust the position of the
motorised product using the
Up
and
Down
buttons.
4) Press the
my
and
Up
buttons at the same time until the
motorised product moves.
The lower end limit is memorised. The motorised product rises
and stops in the upper position.
5) To confirm the end limits, press the
my
button until the
motorised product moves up and down.
The end limits are programmed.
1)
2)
ON
a
b
Modifying the direction
of rotation
Setting the end
limits
1)
2)
1)
2)
1)
2)
3)
4)
5)