3
EN
Oximo 40 Solar io
Copyright
©
2021 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
2.1.2. Preparing the tube
͉
Install the drive in a roller tube with a minimum thickness of 0.5 mm
and a smooth inner surface: with no welding, crimping, folding, etc.
inside the tube.
1) Cut the roller tube to the required length, depending on the
motorised product.
2) Deburr the roller tube and remove the swarf.
3) For roller tubes which
are smooth inside, cut a
notch with the following
measurements:
2.1.3. Drive-tube assembly
1) Slide the drive into the roller tube.
For winding tubes with a smooth interior, position the cut notch
on the crown.
2) The drive wheel must be locked in place to prevent any
movement in the roller tube:
This can be achieved by fastening the winding tube to the drive
wheel using 4 self-tapping screws, Ø 5 mm, or 4 steel pop riv-
ets, Ø 4.8 mm, placed between 5 mm and 15 mm from the
outer edge of the drive wheel, regardless of the roller tube.
Attention
The screws or pop rivets must only be fastened to the drive
wheel and not to the drive.
2.1.4. Mounting the tube-drive assembly
1) Install and fix the drive-tube assembly onto the end bracket (
e
)
and onto the drive bracket (
f
)
.
Attention
Ensure that the drive-tube assembly is secured to the end
bracket. This operation prevents the drive-tube assembly from
coming out of the end bracket mounting.
2)
Depending on the type of bracket, screw the adapter (
g
) onto the
motor head.
2.1.5. Installation of the antenna
Attention
• Do not wind or cut the antenna wire. Observe a minimum
bending radius (
h
) of 9 mm.
• The end of the drive antenna wire must protrude at least
10 cm from the roller shutter housing and be 1 cm from all
metal surfaces.
3)
1)
2)
c
d
L1
L1
1)
2)
L1
L1
f
e
g
1)
2)
≥1 cm
≥10 cm
◀
◀
◀
◀
◀
◀
c
d
Ø 40 x 1
6 mm
8.5 mm
Ø 40 x 1.5
7 mm
8.5 mm
h