![background image](http://html1.mh-extra.com/html/somfy/ilmo2-50-wt/ilmo2-50-wt_instructions-manual_1317625016.webp)
14
EN
ILMO2 50 CSI WT
Copyright
©
2018 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
The motorised product
stops too soon.
The crown is incorrectly positioned.
Fit the crown correctly.
The motorised product encounters friction
when it moves: friction along the runners and
case, interference between the roller tube
and the drive, etc.
Check the motorised product installation and
correct any friction. If the problem continues,
restore the drive to its original configuration.
The drive has been installed in a new
motorised product.
Restore the drive to its original configuration,
see “Restoring the original configuration”.
The motorised product does
not stop when it reaches
the lower end limit.
The mountings used are not correct.
Check that the motorised product is fitted to
the roller tube using rigid links.
The motorised product does
not stop when it reaches
the upper end limit.
The motorised product locking system in the
upper position is not suitable.
Check that the motorised product is fitted
with end stops screwed onto the last slat,
fixed or removable stops incorporated in the
runners or an end slat acting as an end stop.
2.4.2. Restoring the original configuration
2.4.2.1. Using the control point connected to the motorised product
͉
͉
Follow each of the 4 steps in the procedure carefully to correctly restore the original configuration.
1) Position the motorised product at the mid-height position.
2) Repeat the next step 3 times in succession:
• Press the “Up” button until the motorised product moves. Re-
lease the button immediately.
3) Repeat the next step twice in succession:
• Press the “Down” button until the motorised product moves.
Release the button immediately.
4) Press the “Down” button again until the motorised product makes
2 successive movements in the same direction.
The drive is reset to the original configuration.
2.4.2.2. Using the wired electronic motor setting tool
• Press the “Up” and “Down” buttons on the setting cable at the same time until the motorised product makes
two successive up and down movements.
The drive has been restored with the original configuration.
1
2
x 3
3
4
x 2
7s
Summary of Contents for ilmo2 50 WT
Page 1: ...ILMO2 50 CSI WT Notice Instructions Anleitung Istruzioni FR EN DE IT...
Page 2: ......
Page 35: ......