97
m) Tighten the front end and the trim plate using two screws
A
(DIN 912 M5x12) and
two nuts
B
(DIN 6923 M5) in the holes prepared for the purpose see Figure 62.
Important:
Ensure that the front is aligned with the top, it may be necessary to apply
a little force to adjust the parts. In the Alpes K300 it is not necessary to carry out any
operation of this kind.
Figure 62 - Finishing front panel grip on equipment Alpes K400
n)
In order to place the side casings in the case of the Alpes K400, slightly fold
outwards some tabs that are at the top in order to facilitate the assembly of the part
see figure 60-A. In the case of the Alpes K300, it is not necessary to carry out this
process even though it has a slight tab see Figure 63-b.
a)
b)
Figure 63 - Fold the upper tabs on the structural sides
A
A
B
B
10º (Alpes K400)
11º (Alpes K400)
11º (Alpes K400)
Summary of Contents for K100
