Solid State Logic XLogic Super Analogue, Owner'S Manual

Page: 9 / 30

Mains Supply and Phases
Solid State Logic equipment is designed for connection to single phase supplies with the Neutral conductor at
earth potential – category TN – and is fitted with a protective fuse in the Live conductor only. It is not designed
for use with Phase (Live) and Neutral connections reversed or where the Neutral conductor is not at earth
potential (TT or IT supplies).
Mains cables will be coded with the following colour scheme:
LIVE: Brown
NEUTRAL: Blue
EARTH: Yellow/Green
Mains Isolation and Over-Current Protection
An external disconnect device is required for this equipment which must be installed according to current wiring
regulations. A detachable power cord, as fitted to this equipment, is a suitable disconnect device.
An external over-current protection device is required to protect the wiring to this equipment which must be
installed according to the current wiring regulations. The fusing or breaking-current are defined in the product
specification. In certain countries this function is supplied by use of a fused plug.
CE Certification
Note that the majority of cables supplied with SSL equipment are fitted with ferrite rings at each end. This is to
comply with current European CE regulations and these ferrites should not be removed.
If any of the unit metalwork is modified in any way this may the adversely affect the CE certification status of
the product.
FCC Certification
The XLogic unit has been tested and found to comply with the limits for a Class A digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the interference at his own expense.
Page 5
Safety Considerations