Solid State Logic C10 HD, Installation Manual, Page: 224 / 237

S.2 c
hAnneL
c
ontRoL
t
iLe
R
eMoVAL
t
ooLS
n
eeded
:
• 2mm Hex Driver
• Module Pullers (2)
p
RocedURe
1. Shutdown and then switch off the console at both power input panels. Remove both input power leads.
2. Undo and remove three off 2mm screws at the front edge of the tile
and three off 2mm screws at the top edge of the tile.
3. Screw the two module pullers into the outer two fixing holes at the
lower edge of the panel as shown in diagram S2-1.
4. Lift the front of the panel upwards using the pullers until the edge is
free. Now support the panel by hand and continue to lift at the front
until the panel sits vertically on its rear edge.
The connecting cables will prevent the panel from being lifted out of the
frame at this stage.
5. Remove the two connecting cables at the lower rear edge of the
panel as shown below.
RJ45
Network
26W Ribbon
Data + Power
S.2-1
S.2-2
Page 7-2 | Section 7: Service Information C10 HD Installation Manual
Channel Control Tile