Solectek SkyMate, Operator'S Manual

Page: 47 / 124

SkyWay Series Multi-Point Operator’s Guide
33
Creating Source and Destination Filter
1.
Add MAC addresses of the Source and Destination in which you would like to
Filter.
2.
Add the Source and Destination Masks of the Source and Destination IP
address.
3. Set the Access Direction to Input, Output, or Both. This will filter out traffic
coming in, going out, or both in and out of the Filter.
4. Set the Filter Access to Allow or Deny. Allow or Deny traffic going through
the filter from the Destination MAC address.
5.
Type “ .w ” to save the changes.
Creating Filters SNAP, Ethernet, LSAP Frames
These filters will allow the user to filter out frames with SNAP, Ethernet, and
LSAP type of headers.
1. Create SNAP, Ethernet and LSAP frames in the 802.3 formats.
2.
SNAP Data Type: Enter SNAP for the Data type.
3.
The Data Value should be the Protocol Identification of the IPX SNAP header.
4.
Ethernet Data Type: Enter Ethernet for the Data type.
5. Enter the Frame type of the IPX Ethernet header for the Data Value.
6.
LSAP Data Type: Enter LSAP data type.
7. Enter the DSAP and SSAP bytes for the Data Value.
8.
All Data Values should be in hexadecimal format
9.
Set the Data Mask. To deny the entire Frame, set the Data Mask to FFFF.
10.
Set the Filter Direction Input, Output, or Both.
11. Set the Filter to access Allow or Deny.
Note:
Source and Destination features can be used in accordance with this
feature.