LCR FITNESS BIKE
23
GENERAL MAINTENANCE
1. Wipe down all areas in the sweat path with a damp cloth after each workout.
2. If a squeak, thump, clicking or rough feeling develops the main cause is most likely one of
two reasons:
I. The hardware was not sufficiently tightened during assembly. All bolts that were
installed during assembly need to be tightened as much as possible. It may be
necessary to use a larger wrench than the one provided if you cannot tighten the bolts
sufficiently. I cannot stress this point enough; 90% of calls to the service department for
noise issues can be traced to loose hardware.
II. The crank arm nut needs to be retightened
III. If squeaks or other noises persist, check that the unit is properly leveled. There are 2
leveling pads on the bottom of the rear stabilizer, use a 14mm wrench (or adjustable
wrench) to adjust the levelers.
MAINTENANCE MENU IN CONSOLE SOFTWARE
1. Press and hold the Start, Stop and Enter key at the same time, until the display shows
“Engineering Mode”. Press the Enter key.
2. You can now scroll through the menu using the Up and Down keys. Use the Stop key to
return to previous menu selection. The menu selections are:
A. Key Test
B. Display Test
C. Functions
I. Display Mode - Turn Off to have the console power down automatically after 30 minutes of inactivity
II. Pause Mode - Turned On to allow 5 minutes of Pause, turn Off to Pause indefinitely
III. ODO Reset - Resets the Odometer reading to zero
IV. Units - Choose from English(Imperial) or Metric display readings
V. Brake Test - For testing the Brake function
D. Security
E. Factory Settings - For Factory use only
F. Exit
Summary of Contents for LCR Fitness Bike
Page 28: ......