SUPPLY
CABLE
208/240V
11
of 20
Ref No. 043477-EN Rev. A
I N S TA L L AT I O N I N S T R U C T I O N S
Always allow the heater to cool before attempting to reposition/move. Never attempt to
move the heater while it is switched on!
Observe the minimum safe distance between the heater body and inflammable surfaces
and objects when mounting.
Please refer to the specification table for the recommended positioning of the heater with
regards to minimum distances. Do not install the heater in a corner!
Keep out of the reach of children.
Refer to the page 15 for general sizes and dimensions of the base fixing holes.
1
. The terminal box lid can be removed now for installation. The M8 × 20 button head socket
screws and spring washers should be removed and retained while the zip tie should be left
around the curved arms (tubes) until installation is complete. Take the heater assembly off
the base plate and store safely.
CONCRETE
Note. Ensure the base is sitting level so the heater doesn’t lean when assembled.
2
. Having made provision for cabling use, consider one of the following options for fixing the
base to a suitable floor:
Option 1: Preset 1/2” or 12mm bolts in concrete and fasten .
Option 2: Secure the base with nuts & washers into concrete or other similar material.
Note. Total weight of heater is 91lb 8oz (41.5kg)
TERMINAL BOX LID
M8 × 20 BUTTON
HEAD SOCKET
SCREWS & SPRING
WASHERS
3 - OFF
STUDS
NUTS &
WASHERS
HOLES
FLOOR
BOLTS &
WASHERS
