105
16. SETTING-OUT LINE
2. Enter the offset value.
• Offset: How much to move the
baseline.
A positive value indicates right
side and a negative value
indicates left side.
• When not setting offset value, go
to step 3.
3. Sight the target and press
[MEAS]
on the screen of step 2.
The measurement results are
displayed on the screen.
Press
[STOP]
to stop the
measurement.
• The tilt screen is displayed if the
instrument is out of level.
Level the instrument.
4. Press
[YES]
to use the
measurement results.
Displays the difference between
the measured point and the
baseline.
• Offline: A positive value
indicates the point is on the right
of the baseline and a negative
value indicates it is on the left.
• “Cut” indicates that the point is
below the baseline.
• “Fill” indicates that the point is
above the baseline.
• Length: Distance along the
baseline from the first point to
the measured point.
• Press
[NO]
to observe the target
again.
S e t - o u t l i n e
O f f s e t
0 . 0 0 0
m
MEAS
Set-out line
NO
YES
HR
1.400
m
SD
ZA
HA-R