18
EN
ATyS d H - 544077E - SOCOMEC
5.6.5. Mounting & connecting controller
Door mounting
The ATyS C55/C65 can be mounted on doors up to with a thickness 4mm (0.15in).
STEP 1: Cut out for the controller
Cut a rectangle hole of 220x160mm / 8.66 x 6.3in on the enclosure door as shown below.
8.66
+/-0.4
220
+/-1
6.30
+/-0.4
160
+/-1
CAUTION ! For IP65 protection, the gasket must be placed and fitted around the inside
edge of the controller as shown above.
STEP 2: Fixing the controller on the door:
Remove all connectors then place the ATS controller inside the door cut-out and clip the door mounting screws into the
side of the controller (2 screws on each side). It is important to respect the tightening torque indicated below and follow
good engineering practise when installing the ATS controller.
The back of the controller includes fixing points for cable collars (see illustration below).
Screw Tightening torque
PH1 / 0.2 Nm / 1.77 lb.in
Insert the 4 door
mounting screws in
the designated slot
and push back to
lock in place.
Example of cable way.
1
2
10 mm
10 mm
Cable must be more than 10mm away from the RTC battery
cover and USB.
Do not drill holes above the controller after it has been mounted.