3 | S
ETUP FOR
W
INDOWS
7,
V
ISTA
,
AND
XP
This chapter explains how to install and use the
Bluetooth
Cordless Hand Scanner (
Bluetooth
CHS) 7X
or 7XRx with a
Bluetooth
enabled computer running
Windows 7, Vista or XP
Before you begin the instructions in this chapter, make
sure you have charged the scanner, as described in
Chapter 2, “Hardware Setup.”
Note: No software installation is required for normal operation.
STEP
1:
T
URN ON THE
B
LUETOOTH
CHS
Press and hold the small power button for 3 seconds
, or until the LED
turns blue and the scanner beeps twice (low-high). The LED should blink blue
once per second to show that the
Bluetooth
radio is on but not connected.
Time after turning on scanner
Bluetooth
mode
0-5 minutes
Discoverable and connectable
5 minutes
When disconnected and inactive, the
scanner automatically powers off.
2 hours
When connected and trigger button is
not pressed, the scanner automatically
powers off.
STEP
2:
S
TART
B
LUETOOTH
ON
Y
OUR
C
OMPUTER
Note: Refer to your Bluetooth hardware/software documentation for full instructions.
1.
If using an add-on
Bluetooth
adapter plug it into your computer.
2.
Start your computer’s
Bluetooth
software. For some computers, the
Bluetooth
software will automatically launch after you turn on the
Bluetooth
radio.
3.
Turn on the
Bluetooth
radio. For some computers, the
Bluetooth
radio must be
enabled through the software. Other computers have a hardware switch.
CHAPTER 3: SETUP FOR WINDOWS XP, VISTA, AND 7
11
Summary of Contents for 7X
Page 50: ...6 2010 Printed in U S A...