MC500
RollCall Control Panel System Setup Screens
Issue 1 Rev 6
Page 96
© 2015 SAM
10.6.1.1
Setting a Static IP Address
To set a static IP address, you will need to enter all the following information: IP address,
IP gateway (even if you are not using an IP gateway), and IP netmask.
In the following example, we are setting a static IP address of 192.168.1.42.
To set a static IP address:
1.
From the System Menu, select Network.
2.
Under IP Configuration, select Fixed Address.
3.
In the IP Address box, enter
192.168.1.42
and then click S.
4.
In the IP Gateway box, enter
192.168.1.12
and then click S.
5.
In the IP Netmask box, enter
255.255.255.0
and then click S.
Note: To return any box to its default value, click P.
6.
When all addresses are set, you must apply the changes. To do this:
•
Click Apply IP Changes.
The system updates and saves the changes made in the Ethernet menu.
10.6.1.2
Setting a DHCP IP address
1.
From the System Menu, select Network.
2.
Under Ethernet > IP Configuration, select DHCP.
3.
Click Apply IP Changes.
10.6.2 RollCall
The RollCall controls enables you to view and set up the unit’s RollCall attributes for use
remotely with the RollCall Control Panel.
To change the name of the unit:
1.
In the Change Name field, type a new name for the unit.
2.
To save the memory name, click S. To return the memory to its default value, click P.
Note:
You must disconnect the unit from your Local Area Network before setting a static IP
address to avoid IP conflicts on the network.
Note:
If the combination of IP address, IP gateway, and IP netmask in invalid, the system will not
update the IP address.
Note:
If you make any changes to the settings in the Ethernet menu, you must click Apply IP
Changes to confirm the changes.
