Not for
Reproduction
6
If you need assistance with assembly of the unit, please
contact the web site or phone number shown in the
Customer Contact Guide (if provided) or the Operator’s
Manual.
WARNING
Failure to read and follow the safety warnings and
instructions in this document and in the operator’s
manual could result in death, serious injury, and/or
property damage.
The warnings and instructions must be read,
understood, and followed when starting up,
operating, servicing, transporting, or storing the unit.
Charge Battery
1
WARNING
Always wear safety glasses when working
around batteries.
Hazard -
Batteries produce explosive gases.
• Always leave vent caps in place to avoid
explosions.
• Keep all sparks, flames, and cigarettes away from
batteries at all times.
• Never attempt to charge a frozen battery. Allow it to
warm to 60° F (15.5°C) before charging.
Corrosive Liquid Hazard -
Batteries contain
sulfuric acid.
• Never lean over the battery when performing
maintenance.
Lead Hazard -
Battery posts, terminal and related
accessories contain lead and lead compounds.
Wash hands after handling.
NOTICE:
Voltage Spikes can damage the electronics. To avoid
such damage please follow these instructions carefully.
Never
use a battery charger to directly start the engine.
Use only a fully charged battery properly installed.
Never
charge the battery with the NEGATIVE (-) black
cable attached to the battery terminal. Keep the loose
black cable away from the battery.
1
Make sure the ignition is OFF and the key or the
starter insert is removed.
2
Charge battery according to the instructions provided
by the charger manufacturer.
3
After charging attach positive (+) cable (red) first.
4
Cover (+) terminal with boot (red).
5
Attach negative (-) cable (black).
6
Wash hands after handling.
Install Seat
2
Install bolts and tighten to 7.6 Nm (66 lb-ft).
Install Ground Speed Levers
3
LEVER HEIGHT and ANGLE OPTIONS - (A/B/C) The
bolts need to be spaced so there is a hole open in
between.
Check the Tire Pressure
4
The tires may be over-inflated for shipment.
WARNING
Over-inflating tires may cause them to explode
which could result in serious injury.
DO NOT inflate the ti
res above themaximum pressure
(stamped on thesidewall of the tires).
Check Oil Level
5
1
See operator’s manual for oil specifications.
2
Place the zero turn on a level surface.
3
Remove dipstick.
4
Keep oil level in the operating range.
Safety Interlock System Tests
6
This Zero-Turn is equipped with several mechanical safety
systems designed to keep the operator safe while using
the unit. Check the operation of these systems using the
safety systems tests listed in the Operator’s Manual.
Mower Deck
7
See the Mower Deck Manual for deck leveling and
installation/ removal.
en
