20
Torque AND Angle Mode
Torque AND Angle mode is setup by first setting a target torque and units then a target angle before
selecting Torque AND Angle mode. In Torque AND Angle mode, torque and angle are measured
simultaneously. Yellow progress lights track torque measurement. When both torque and angle reach
their targets, green progress lights turn on and torque and angle data record is stored. If either of
measurements exceed their upper tolerance, red progress lights turn on.
1.
From target torque screen, use
UP/DOWN
buttons to set target torque and
UNITS
button to select
torque measurement units then press
ENTER
button.
2.
Angle target screen is displayed. Use
UP/DOWN
buttons to set target angle then press
ENTER
button until Torque AND Angle mode screen is displayed.
3.
Apply torque and rotate wrench until both targets are reached.
Note:
UNITS
button can be used to select torque units while on Torque AND Angle screen.
Note: Torque THEN Angle Presets are entered by pressing and holding Units button while on Torque
THEN Angle screen. Refer to "Adding a Torque Preset" and "Adding an Angle Preset" in Basic
section for parameter entry.
Note: Torque cycle is not recorded in memory unless both torque and angle reach targets.
Note: Red progress lights turn on if torque exceeds plus tolerance or if angle exceeds
plus tolerance while in manual mode.
Note: Red progress lights turn on if torque exceeds maximum torque or if angle exceeds maximum
angle in Preset mode.
Preset Lock
Preset Lock function allows user to lock wrench so that only configured presets are accessible. No
other presets can be configured and manual target torque and angle modes are not accessible when
locked.
Note: Password entry is required to enable Preset Lock. When locked, password entry is required to
re-enter Configure menu (refer to ControlTech™ Micro Calibration manual for default
password).
1.
From Configure menu, use
UP/DOWN
buttons to highlight
PRESET LOCK
selection then press
ENTER
button.
2.
Preset Lock enable/disable screen is displayed.
3.
Use
UP/DOWN
buttons to select LOCK or UNLOCK selection.
4.
Press
ENTER
button to accept selection and exit to Configure menu.
00
100.0
IN-LB
ENTER
button
ENTER
button
UP/DOWN
buttons
00
45°
00
TQ: 100.0 IN-LB
AND ANG: 45°
UP/DOWN
buttons
ENTER
button
EXIT
MODE SETUP
PRESET LOCK
EXIT
MODE SETUP
PRESET LOCK
UP/DOWN
buttons
ENTER PASSWD
0
0
0
0
0
UP/DOWN
buttons
Password screen
ENTER
button
PRESET LOCK
LOCK
UNLOCK
UP/DOWN
buttons
PRESET LOCK
LOCK
UNLOCK
ENTER
button
EXIT
MODE SETUP
PRESET LOCK
Lock icon
PSET 01
03
100.0
IN-LB
EXIT
MODE SETUP
PRESET LOCK
UP/DOWN
buttons
ENTER
button
Summary of Contents for ControlTech Micro
Page 35: ...34 ...