21
Note: If LOCK is selected without a Preset configured, following screen is displayed:
Note: When Preset Lock is enabled, Clear Memory function is disabled and displays following Locked
message if attempted:
Note: When Preset Lock is enabled, Clear Cycle count function is disabled and displays Locked message
if attempted.
Preset Unlock
When Preset Lock is enabled, a password is required to access Configure menu. Refer to ControlTech™
Micro Calibration Manual for Configure password.
1.
From target torque or angle screen, press and hold
ENTER
button
for 3 seconds.
2.
Highlight
CONFIGURE
menu selection using
UP/DOWN
buttons.
3.
Press
ENTER
button
to display Password screen.
4.
Follow password entry procedure found in ControlTech™ Micro Calibration manual.
Delete Presets
Delete Presets function allows user to delete all presets at once.
1.
From Configure menu, use
UP/DOWN
buttons to highlight
DELETE PRESET
selection then press
ENTER
button.
2.
Delete Presets confirmation screen is displayed.
3.
Use
UP/DOWN
buttons to select YES or NO selection.
4.
Press
ENTER
button to accept selection and exit to Configure menu.
Note: If Delete Presets is selected without a Preset configured, following screen is displayed:
Job Mode
LOCKED
PRESS TO
CONT.
NO PRESETS
PRESS TO
CONT.
NO PRESETS
PRESS TO
CONT.
UP/DOWN
buttons
ENTER
button
held
Preset Screen
ENTER
button
EXIT
SET HEAD LENGTH
SHOW DATA
LANGUAGE
SETTINGS
CONFIGURE
ENTER PASSWD
0
0
0
0
0
PSET 01
03
100.0
IN-LB
UP/DOWN
buttons
ENTER
button
UP/DOWN
buttons
Delete Presets menu
EXIT
MODE SETUP
PRESET LOCK
MODE SETUP
PRESET LOCK
DELETE PRESETS
DELETE PRESETS
YES
NO
Summary of Contents for ControlTech Micro
Page 35: ...34 ...