Snap-on Equipment EEWA717A, Operator'S Manual

Page: 63 / 66

Maintenance
61
As the system acquires the different pods in the area it will start
displaying the MAC numbers on the screen. For instructional
purposes only the system has located 4 pods in the area, this
could happen if there are two or more aligners in the area.
Once the system has finished finding all the pods the system will
then begin the process of marrying the pods to the aligner. This
process will start at the top of the list working it’s way down. the
system will highlight a pod number and ask the user if the LED’s
on any of the pods being married are flashing.
Look at both pods. If the LED’s on any of the pods are flashing click
on <OK>.
If the system does not locate 2 pods the user is instructed to power
down both pods and press the scan button again.
If after 3 attempts the system does not locate the pods it will be
necessary to call technical support to generate the POD MAC
numbers and enter them manually. This is done by clicking on the
<CANCEL> button in step 4 and entering the Pod Identification for
the respective Pods and pressing <OK>. (Before calling technical
support locate the number of the radio pod by removing the rear
bumper from each pod.)