15
Assembly
Step 15: Sear Burner Assembly
Locate
: Sear Burner Housing and Lid (Part
21), Sear Burner, Sear Burner Control Knob,
(7) M6x15 bolts and (2) ST4.2 x10 Screws.
Procedure
:
Screw (4) M6x15 bolts into the (4) threaded
holes in the left side of the grill cabinet as
shown in Figure 15A, and leave about 1/4” of
each screw sticking out.
Hang the sear burner housing onto the grill
cabinet, so all (4) bolts fit into the holes of the
sear burner housing.
Add (3) additional
M6x15 bolts from INSIDE the Cabinet to
secure the Sear Burner as
show in Figure
15B, and tighten the bolts. Note: (2) bolts are
tightened from the underside of the sear
burner housing.
The next step is to attach the sear burner
valve to the sear burner housing. Remove the
(2) M4x8 screws from the sear burner valve
as shown in Figure 15C. Then position the
valve in place between the front panel of the
sear burner housing and the inner wall as
shown in Figure 15D. Align the threaded
holes in the valve with the holes in the sear
burner housing and attach using the (2) M4x8
bolts that were removed earlier.
Place the sear burner control knob over the
valve stem, making sure to align flat portion of
both components, and push the control knob
over the stem until it is firmly seated. See Fig-
ure 15E. Use this same procedure to install
the (3) gas control knobs on the gas grill con-
trol panel.
(Sear Burner Assembly continued on next
page)
Step 15
Fig. 15A
Fig. 15D
Fig. 15E
Fig. 15B
Fig. 15C
