16
Assembly
(Step 15: Sear Burner Assembly Continued)
Locate the sear burner, tilt the sear burner up
and slide the tube through the inner wall and
onto the valve as shown in Figure 15F. From the
underside of the sear burner housing, check to
make sure the valve is inside the tube as shown
in Figure 15G.
Now attach the Sear Burner to the bracket lo-
cated on the back wall of the Sear Burner Hous-
ing using (2) ST4.0 x10 Screws as shown in Fig-
ure 15H.
Remove the large nut from the igniter as shown in
Figure 15I, push the other end of the wire through
the hole into the underside of the housing. And
slide the wire through the nut and through the hole
on the outside of the housing.
Attach the wire to the stem of the igniter. Push
the igniter and wire through the hole and attach it
to the housing by screwing the nut back onto the
igniter. Figure 15J.
Step 16: Attach Retaining Wire for LP Gas
Cylinder
Locate
: Retaining Wire (Part #25).
Procedure
:
Attach retaining wire to legs at left end of grill as
shown in Figure 16. Position the retaining wire
inside the legs and under the grill body with the
curved side up. Then insert the ends of the wire
through the holes in the legs and rotate the wire
toward you.
Step 16
Fig.16
Retaining Wire
Fig. 15 F
Fig. 15 G
Fig. 15 H
Fig. 15 I
Fig. 15 J
