11
Assembly
Step 9
Step 9: Install Grease Pan Connector
Locate
: Grease Pan Connector and (2)
M6x15 bolts.
Procedure
:
Place the grease pan connector inside the left
end of the cabinet just below the horizontal
slot and insert (2) M6x15 bolts from outside
the cabinet as shown in Figure 9.
Fig.9
Step 10
Fig. 10A
Fig. 10B
Step 10: Install the Drip Tray Guides
(Right, Left and Center)
Locate
: Sides Drip Tray Guides, Center Drip
Tray Guide and (10) M6x15 bolts.
Procedure
:
Place side drip tray guide inside the right legs
as shown in Figure 10A and attach using (4)
M6x15 bolts.
Place side drip tray guide inside the left legs
as shown in Figure 9B and attach using (4)
M6x15 bolts. Be sure the LP gas line is posi-
tioned outside the left drip tray guide as
shown in Figure 10B.
From in front of the grill, find the threaded hole
on the underside of the cabinet and partially
insert an M6x15 bolt as shown in Figure 10C.
Position the center drip tray guide so that the
keyhole fits over the partially installed bolt
(See Figure 10D). Then push the guide to-
ward the back of the grill cabinet so that the
tab fits over the threaded hole in the lower
back side of the cabinet and insert an M6x15
bolt as shown in Figure 10E. Fully tighten
both M6x15 bolts.
Fig.10C
Fig.10E
Fig.10D
Stop tab
