11
EN
Canister selection
Device is to be used with RENASYS™ GO 300ml or
750ml canisters.
RENASYS GO canisters use an integral two stage
bacterial filter for protection of device against overflow
and spread of aspirated micro-organisms.
Canisters are designed for single patient use.
Do not re-use.
Canisters are provided non-sterile and should not be
used in a sterile field.
Canisters should be changed at least once a week,
whenever there is a change in patient or in the
event the canister contents reach maximum volume
indication (300ml or 750ml fill line).
Do not wait for
alarm activation to change canister
.
Canisters may have to be changed regularly within
single-patient treatment episodes if exudate levels
are high. Check canisters regularly to monitor exudate
levels, ensuring they are below maximum volume
indication (300ml or 750ml fill line).
Check canister for any signs of cracks or damage. If
noted, discard and replace canister.
Ensure canister viewing window is checked frequently
for signs of bleeding.
For patients with high risk of bleeding, use 300ml
canister.
Note:
Change or replace canisters that have been
dropped or mishandled even if no visible signs of
damage are present to ensure correct operation of
software alarms for leak and blockage.
Dressing changes
Refer to instructions for use provided with dressing
kits for additional information on dressing use and
maintenance.
1.
Foam dressings should be changed every 48 to
72 hours after the initial application of therapy. If
no leak is present and the patient is comfortable,
subsequent dressing changes should occur no
less than 3 times per week.
2.
Gauze dressings should be changed 48 hours
after the initial application of therapy. If no leak is
present and the patient is comfortable, subsequent
dressing changes should occur 2–3 times per
week.
3.
In the event of heavy or viscous drainage, drainage
with sediment or when blood is present, regular
monitoring and more frequent dressing changes
may be required.
4.
When dressing a wound involving a difficult to seal
anatomy or exposure to external moisture, frequent
inspection of dressing is recommended to ensure a
seal is maintained. Ensure wound dressing is fully
compressed and firm to the touch.
5.
Ensure all wound filler material placed in the
wound has been removed before redressing the
wound. If foam dressing adheres to the wound,
apply saline into the wound dressing and let it
set for 15–30 minutes before gently removing the
foam. Appropriately discard used wound dressings
observing your institution’s protocol for medical
waste handling.
6.
As with all adhesive products, apply and remove
dressing carefully from sensitive or fragile skin
to avoid skin stripping, especially after frequent
dressing changes. Use of skin sealant may assist
with protection of periwound skin.
7.
Monitor patient for any signs of local or systemic
infection by checking dressing frequently. Infected
wounds may require more frequent dressing
changes. As NPWT is not intended to directly
treat infection, if there are any signs of systemic
infection or advancing infection at wound area,
contact treating clinician immediately.
10966 175239 Rev02 260917.indd 11
27/09/2017 09:09
