73
Instructions for the user
10.5 what to do if...
The oven display is full
off
• Check the mains power supply.
• Check whether an omnipolar switch
upstream from the oven power supply line is
in the “ON” position.
The oven does not
heat up
• Check whether the “showroom” mode has
been set, for further details see point “7.8
Secondary menu” on page 53.
The controls do not
respond.
• Check whether the “child lock” mode has
been set, for further details see point “7.8
Secondary menu” on page 53.
The cooking times are
longer than those
indicated in the table.
• Check whether the “2300 W” mode has been
set, for further details see point “Secondary
menu” on page 53.
After the automatic
“pyrolysis” cleaning
cycle (only on some
models) it is not
possible to select a
function.
• Verify whether the door interlock device has
switched off. If it has not, the oven has a
protection device that does not allow
functions to be selected while the door
interlock device is active. This is because the
temperatures inside the oven are still too
high to permit any type of cooking.
The display shows
ERR 4
(on pyrolytic models
only)
• The door interlock device has not hooked up
to the door properly. This might be because
the door was accidentally opened during its
activation. Switch off the oven and switch it
on again waiting a few minutes before
selecting a new cleaning cycle.
If the door is opened
during a fan-assisted
function, the fans
stops.
• This is not a fault. It is a normal operation of
the appliance, useful when cooking foods in
order to avoid excessive heat escaping.
When the door is closed, the oven will return
to normal operation.
If the problem has not been resolved or for other types of faults, contact
your local technical assistance centre.
