10
6 SET-UP
6.1
Glasswasher parameter modification procedure:
Only accessible after filling is complete or with the door open.
Indicator lights showing: off; green; orange;
flashing.
Access “programming mode”
With the tank empty (during “FILL”)
1- Switch on the appliance; the display will show “FILL”
2- Open the door/lift the hood (depending on the model)
3- Press the button once. The display will show “UNLO”.
4- Close the hood/door (depending on the model).
5 - Press the button and hold it down for 5/7 seconds.
When the second beep is heard, release the button and
press it again to access the main PCB setup menu.
With the tank full (during “P1 – P2 – P3 – P4”)
1- Press the button once. The display will show “UNLO”
2 - Press the
button and hold it down for 5/7 seconds.
When the second beep is heard, release the button and
press it again to access the main PCB setup menu.
Rinsing temperature (boiler temperature)
IMPORTANT:
Whenever the type of detergent or rinse aid is changed
, it is
ABSOLUTELY ESSENTIAL
to
flush out
the peristaltic pumps
by placing the external intake pipes in water for a few cycles.
Always
use
only products
specifically recommended
for use in a glasswasher.
Failure to comply
with this
recommendation leads to
forfeiture of the warranty entitlement
on the appliance’s water system.
The
internal pipes of the detergent and rinse aid pumps
should be replaced by the After-Sales
Service
every 12 months or 15,000 wash cycles
and operation of the diaphragm can be disposed
of in accordance with the relevant regulations rinse aid pump should be checked.
Set-up
During first start-up, the functions/parameters listed below must be set or adjusted:
Summary of Contents for PROFESSIONAL GLASSWASHER
Page 1: ...PROFESSIONAL GLASSWASHER ...
