10
Please note:
If the appliance is not used for long periods, disconnect from the
electricity supply as follows:
• first turn the appliance off by pressing the button
(fig. 9);
• release the main switch (A23) situated on the side of the
appliance (fig. 2).
Important!
Never press the main switch while the appliance is on.
MENU SETTINGS
Rinsing
Use this function to supply hot water from the coffee spouts
(A13) to clean and heat the appliance’s internal circuit. Place a
container with a minimum capacity of 100ml under the coffee
and hot water spouts (fig. 8).
To enable the function, proceed as follows:
1. Press (B2) to enter the menu;
2. Press (B10) or
(B8) until the display shows (B)
RINSING;
3. Press to start rinsing.
Danger of burns!
Do not leave the appliance unattended while hot water is being
delivered.
1. After a few seconds, hot water comes out of the coffee
spout which cleans and heats the internal circuit of the
appliance: the following message is shown on the display
RINSING HOT WATER RUNNING as well as a progress bar
which fills up as the preparation progresses;
2. To stop the rinsing cycle, press
or wait for rins-
ing to stop automatically.
Please note:
• If the appliance is not used for more than 3-4 days, when
switched on again, we strongly recommend doing 2/3 rins-
es before use;
• After rinsing, it is normal that there is some water in the
grounds container (A10).
De-scaling
For instructions on de-scaling, see section “De-scaling”.
Water filter
For instructions on how to install the filter (C4), see section
“Water softener filter”.
Beverages settings
In this section, you can consult your customised settings and, if
you wish, reset the default values for each beverage.
1. Press (B2) to enter the menu;
2. Press (B10) or
(B8) until
DRINKS SETTINGS
appears on the display (B);
3. Press : The values for the first beverage appear on the
display;
4. The reference user profile is highlighted on the display. The
values are shown on the vertical bars: the manufacturer de-
fault value is indicated by the symbol
while the cur-
rent set value is highlighted by the filled part of the vertical
bar;
5. To go back to the settings menu, press
.
To scroll and display the beverages, press
;
6. To return to the default manufacturer values for the bever-
age shown on the display, press
RESET;
7. CONFIRM RESET?: to confirm, press
(to cancel,
press
);
8. RETURN TO FACTORY: press
.
The beverage has been reset to the default values. Continue with
the other beverages, or go back to the settings menu.
Please note:
• To change the beverages for another profile, go back to the
homepage, select the required profile (B11) and repeat the
procedure.
• To reset all the beverages in the profile to the default val-
ues, see paragraph “Manufacturer Default values”.
Set time
To adjust the time on the display (B), proceed as follows:
1. Press
(B2) to enter the menu;
2. Press (B10) or
(B8) until the display (B) shows
SET TIME;
3. Press : The time setting panel appears on the screen;
4. Press or
corresponding to the hours and minutes
until the current time is displayed;
5. To confirm, press
(to cancel, press
), then
press
to go back to the homepage.
The time is now set.
Auto-start
The auto-start time can be set in order to have the appliance
ready at a certain time (for example in the morning) so that it
can immediately make coffee.
