![background image](http://html1.mh-extra.com/html/smc-networks/smcco10-z/smcco10-z_user-manual_1299212005.webp)
SMCCO10-Z CO Alarm User Guide
Copyright
©
2013 SMC Networks
Page 5
All Rights Reserved
I/M SMCC010-Z rev. 1.0
1/23/2013
9/3/10
B.
Insert the supplied two screws and
secure the mounting plate to the
wall or ceiling surface. If mounting
in plasterboard or drywall, drill a
3/16 in. hole and use the plastic
anchors provided.
C.
After the mounting plate is secured,
slide the alarm over the mounting
plate (see Figure 5 on page 6).
D.
Pull out the battery pull tab to
power-up the SMCCO10-Z.
E.
Two labels are provided that have
important information on what to do
in case of an alarm. Record the
phone number of your emergency
service provider in the space
provided. Place one label next to
the SMCCO10-Z after it is mounted,
and the other label near a fresh-air
source, such as a door or window.
5
Installng/RepacingBatteries
The SMCCO10-Z comes with 3 batteries
preinstalled. When you need to replace
them, use the following procedure with
one of the following approved brands,
which can be purchased at your local
hardware store:
Duracell MN1500 or MX1500
Energizer E91
Using a different battery can affect the
alarm operation detrimentally.
A.
Place the Touchscreen into sensor
test mode. Otherwise, an
alarm/tamper condition may be
indicated.
B.
Slide the alarm body off of the
mounting plate.
C.
Remove the old batteries and
dispose of them properly, as
recommended by the battery
manufacturer.
D.
Install the new batteries. Note the
polarity shown in the battery
compartment (see Figure 4).
Figure 4. Installing Batteries