Power Supply Receptacles and Status LEDs
There are two power receptacles on the rear of each switch.
The standard receptacle labeled “Power” is for the AC power
cord. The 14-pin receptacle labeled “DC Input” is for the
optional Redundant Power Unit (RPU).
Figure 2-9. Power Supply Receptacles
Power and RPU LEDs located on the front panel of each switch
indicate the status of both the internal and redundant power
supplies. These LEDs are described on the following page.
Figure 2-10. Power Supply LEDs
2-10
A
BOUT THE
S
WITCHES
Summary of Contents for SMC6516FF
Page 95: ...and the operating mode half or full duplex 5 37...
Page 96: ...SNMP Protocol 6 2 Using RMON 6 3 MIB Objects 6 3 6 1 CHAPTER 6 MANAGING VIA SNMP AND RMON...
Page 110: ...Introduction C 2 Windows Terminal C 3 APPENDIX C SAMPLE CONFIGURATION C 1...
Page 113: ...Troubleshooting Chart D 2 APPENDIX D TROUBLESHOOTING D 1...
