Link and Select LEDs
Each of the RJ-45 connectors on the 10BASE-T and 100BASE-TX
ports has dual integrated LEDs. The left LED displays the port’s
Link status. If this LED is lit (green), it indicates that the con-
nection between the port and the attached device is good. The
right LED, when lit (yellow), indicates that the full status of the
port (Receive, Collision, Full Duplex and 100 Mbps data rate) is
displayed by the shared vertical LED array (see “Shared Vertical
LED Array and Port Select Button” on the next page).
Figure 2-6. RJ-45 Integrated LEDs
The 100BASE-FX ports have individual Link and Select LEDs that
perform the same functions.
The Link and Select LEDs are described in the following table:
*
Note:
The Link LEDs on unconnected ports will blink approximately
once every 5 seconds. This blinking reflects background diagnostics
run automatically by the switch and is not indicative of any error.
2-7
A
BOUT THE
S
WITCHES
Link and Select LEDs
Function
Condition
Description
Link
Off
Port is not in use, attached device is
not powered on, or port has been
disabled via SNMP or Console port
Blinking*
Connection between port on switch
and attached device is bad
Green
Connection between port on switch
and attached device is good
Select
Yellow
Port is selected to drive the vertical
LED array
Summary of Contents for SMC6516FF
Page 95: ...and the operating mode half or full duplex 5 37...
Page 96: ...SNMP Protocol 6 2 Using RMON 6 3 MIB Objects 6 3 6 1 CHAPTER 6 MANAGING VIA SNMP AND RMON...
Page 110: ...Introduction C 2 Windows Terminal C 3 APPENDIX C SAMPLE CONFIGURATION C 1...
Page 113: ...Troubleshooting Chart D 2 APPENDIX D TROUBLESHOOTING D 1...