![background image](http://html.mh-extra.com/html/smc-networks/jxc-1-series/jxc-1-series_supplementary-operation-manual_1300024027.webp)
-26-
JXC
※
-OMX0018
Set stroke is
outside the
stroke limit.
(01-052)
Stroke
limit
B
Turn
ON
RESET
<Contents>
The actuator goes outside the stroke limit specified by the
basic parameters, "Stroke (+)" and "Stroke (-)" if it performs the
requested operation. (Including JOG operation after return to origin)
<Countermeasure>
Make sure that the basic parameters, "Stroke (+)"
and "Stroke (-)" are consistent with the distance of actuator movement
specified in the step data.
Caution
If the operation method of step data is "relative coordinated
movement", note the location where the operation starts and the
distance traveled. If the location is out of the stroke range when the
power is supplied, this alarm is generated. Move the table within
stroke range, and supply power.
Alarm
_Comment
_058
(01-058)
3A
B
Turn
ON
RESET
<Content>
This alarm occurs when the following parameters are
outside of the settable range during the numerical instruction
operation. (Settable range)
(1) AREA 1 < AREA 2
(If both Area 1 and Area 2 are 0, the alarm will not be activated)
(2) Trigger LV
≤ Pushing force
(3) Minimum speed of actuator
≦
Pushing speed
≦
Speed
(4) Pushing speed
≤ Maximum pushing speed of actuator
(5) Pushing force
≥ Minimum pushing force of actuator
(6) Basic parameter "Maximum pushing force"
≥ Minimum pushing
force of the actuator
(7) Basic parameters "Max pushing force"
≥ Trigger LV
<Countermeasure>
Modify the basic parameter setting.
Caution
Refer to the actuator operation manual or catalogue for the
maximum pushing speed, minimum pushing force, and minimum
speed for the actuator.
Alarm
_Comment
_061
(01-061)
3D
B
Turn
ON
RESET
<Content>
This alarm occurs when specifying step data based on
unregistered step data No. or when the numbers of the Movement
MOD is specified out of range during numerical instruction operation
.
(When operation is commanded through a PLC, this alarm will be
generated depending on the input signal interval and the holding time
of signals)
<Countermeasure>
(1) Make sure that the
“Movement MOD” of the step data is not "Blank
(Disabled)" or a number other than [1 (ABS)] and [2 (INC)] are input
in the numerical instruction operation.
(2) Both PLC processing delay and controller scan delay are
generated. Ensure that 2 times or more of the communication cycle
time is maintained between the input signals.