![background image](http://html1.mh-extra.com/html/smc-networks/idf100f-30-w-series/idf100f-30-w-series_operation-manual_1299703031.webp)
IDX-OM-M051
Air Dryer
3.Start and stop
3.6 Display of controller
3 - 3
IDF100F~150F-W
3.6 Display of controller
- Check the controller of the product to find out the condition of the protective equipment.
Caution
∗
Beware of electrical shock when the front panel of the product is removed.
Do not touch the terminals.
When the protective equipment operates, the product will stop operating. In that case, refer to Chapter 5
and eliminate the cause of stopping before restarting.
The automatic reset type protective equipment can be reset by turning off the switch with lamp.
The manual reset type protective equipment can be reset individually by turning off the switch with lamp
and in accordance with the procedure shown in 5.2.
Caution
Allow at least 3 minutes before restarting the product. If the product is restarted within 3
minutes, it can fail to start, or it may start and then stop again.
Display
Content
Protective equipment
On
Normal
Off
The power supply is incorrectly
connected or interrupted.
On
Normal
Off
Over current is flowing to the
compressor.
On
Normal
Off
The refrigerant pressure has
abnormally increased or decreased.
On
The remote operation signal is received.
Off
The remote operation signal
is
not
received.
Condition
Automatic reset type
Manual reset type
0
1
Compressor thermal relay
Phase reverse relay
3
4
High pressure/Manual reset type
Low pressure/Automatic reset type
Remote operation signal
Refrigerant pressure switch
6
4
2
0
7
5
3
1
6
4
2
0
7
5
3
1
6
4
2
0
7
5
3
1
Controller
Display of condition
Detail view