M
ULTICAST
C
ONFIGURATION
2-73
Command Attributes
•
IGMP Status
— When enabled, the switch will monitor network
traffic to determine which hosts want to receive multicast traffic. This
is also referred to as IGMP Snooping. (Default: Disabled)
•
Act as IGMP Querier
— When enabled, the switch can serve as the
Querier, which is responsible for asking hosts if they want to receive
multicast traffic. (Default: Disabled)
•
IGMP Query Count
— Sets the maximum number of queries issued
for which there has been no response before the switch takes action to
solicit reports. (Default: 2, Range: 2 - 10)
•
IGMP Query Interval
— Sets the frequency (in seconds) at which
the switch sends IGMP host-query messages. (Default: 125,
Range: 60 - 125)
•
IGMP Report Delay
— Sets the time (in seconds) between receiving
an IGMP Report for an IP multicast address on a port before the
switch sends an IGMP Query out of that port and removes the entry
from its list. (Default: 10, Range: 5 - 30)
•
Query Timeout
— Sets the time (in seconds) the switch waits after
the previous querier has stopped querying before it takes over as the
querier. (Default: 300 seconds, Range: 300 - 500)
•
IGMP Version
— Sets the protocol version for compatibility with
other devices on the network. (Default: 2, Range: 1 - 2)
Notes: 1.
All systems on the subnet must support the same version.
2.
Some attributes are only enabled for IGMPv2, including
IGMP Report Delay and IGMP Query Timeout.
Summary of Contents for 6750L2
