S
PANNING
T
REE
C
OMMANDS
3-85
bridge forward-time
Use this command to configure the spanning tree bridge forward time
globally for this switch. Use the
no
form to restore the default.
Syntax
bridge
bridge-group
forward-time
seconds
no bridge
bridge-group
forward-time
•
bridge-group
- Bridge group index (bridge 1).
•
seconds
- Time in seconds. (Range: 4 - 30 seconds)
• The minimum value is the higher of 4 or [(max-age / 2) + 1].
Default Setting
15 seconds
Command Mode
Global Configuration
Command Usage
This command sets the maximum time (in seconds) the root device will
wait before changing states (i.e., listening to learning to forwarding).
This delay is required because every device must receive information
about topology changes before it starts to forward frames. In addition,
each port needs time to listen for conflicting information that would
make it return to a blocking state; otherwise, temporary data loops
might result.
Example
Console(config)#bridge 1 forward-time 20
Console(config)#
Summary of Contents for 6750L2
