Smartwatch H20SWDVR16, Operation Manual, Page: 49 / 181

SmartWatch DVR Operation Manual
48
5.1 Configuring Encoding Parameters
Purpose:
By configuring the encoding parameters you can define the transmission stream type, the resolution and so on.
Before you start:
1. Make sure that the HDD has already been installed. If not, please install a HDD and initialize it.
(Menu>HDD>General)
Figure 5.1 HDD- General
2. Check the storage mode of the HDD
1) Click Advanced to check the storage mode of the HDD.
2) If the HDD mode is Quota , please set the maximum record capacity and maximum picture capacity.
For detailed information, see Chapter 10.5 Configuring Quota Mode .
3) If the HDD mode is Group , you should set the HDD group. For detailed information, see Chapter
5.9 Configuring HDD Group for Recording .
Figure 5.2 HDD- Advanced
Steps :
1. Enter the Record settings interface to configure the encoding parameters:
Menu>Record>Encoding
Figure 5.3 Encoding Parameters-Main Stream
2. Set encoding parameters for main stream.
1) Select Record to enter the main stream settings interface.