7
IMPORTANT NOTE BEFORE INSTALLING
This section gathers significant information about the system operation or
its accessories.
ADVICE BEFORE INSTALLING
1. The kit accessories are already programmed in the station BUT extra accessories must be learned
by the station so they can dialogue with it.
2. The accessories have an initialization delay, it is therefore imperative that to insert the batteries in
each accessory 5 to 10 minutes before to start programming or tests.
3. To learn more easily new accessories, arrange all items to be programmed on a table in front of you,
before mounting at the planned location.
SYSTEM OPERATION
1. When movement detectors are installed (cover closed), they have a battery saving system which
disables the detector for about 1 minute after each detection and the indicator diode remains
switched off. In this way, continuous motions in front of a PIR do not use the batteries.
Therefore when you test the system in normal mode, you need to wait two minutes before you
pass
2. The battery life calculation is theoretical, the average detector consuming can vary, and tests and
installation phases consume batteries significantly.
Hence, the first set of batteries does not last as long as the indicated life. The life of new batteries
should be longer because there will not be a programming phase nor any test to be done. The 2 year
life is therefore given as an indication and it may vary depending on several parameters (realized test,
passing frequency in front of PIR detectors, number of door/window openings, etc.).
3. The microswitches in the magnetic detector must not be altered, unless you use an external contact
(see page 24).
TELEPHONE TRANSMITTER AND UNBUNDLING
1. The station phone transmitter behaves as a traditional telephone set, thus it can call landline
numbers as well as mobile phone numbers.
When you get in full or partial unbundling, the Internet service provider allows you to connect q
traditional phone directly on their BOX. If you choose to do so, you can connect the phone transmitter
to make it work properly.
2. Note that in some rare cases, connecting a phone transmitter on a BOX can cause a synchronization
loss, hence an operation problem.
If you face this kind of issue, you just have to replace the pull-out filter (supplied by your Internet
service provider) by a master filter (it is a filter with an enhanced filtration capacity), which will
address the synchronization loss issue.
3. If a phone is already connected to the BOX phone outlet, you have to buy a Y with 1 inlet and
2 outlets (1 for the phone and the other one for the transmitter).
