13
3.2 Installing and programming accessories
3.2.1 Detector learning
TABLE: DETECTOR OPERATION DEPENDING ON THE STATION ARMING MODES
STATION ARMING MODE
PARAMETERS
TOTAL ARMING
PARTIAL ARMING
DISARMING
AREA 1*
DETECTOR ACTIVE
DETECTOR INACTIVE
AREA 2*
DETECTOR ACTIVE
DETECTOR INACTIVE
PANIC *
DETECTOR ACTIVE
* 10 detectors maximum per area
To program a detector:
- Enter 1234 (or your personal code), followed by *,
a long beep will be emitted and the STATUS LED
will flash.
- Push the learning button of the accessory to be
added (see adjacent drawing). When the signal is
received, a long beep will be emitted and the Area
1, 2 and PANIC LEDs will flash successively.
- Select the detector area. Push key 1 for area 1,
key 2 for area 2 and key 3 for PANIC area, a long
beep will be emitted.
Note: If an accessory is not properly detected by
the station, then the station will exit the learning
mode after 30 seconds and you will have to start
again the procedure.
3.2.2 Deleting detectors
The station cannot delete independently every
accessory. If you want to delete an accessory, you
must also delete all items present in the sane area. This means that you must reprogram the other accessories of
the deleted area.
To delete an area:
- Enter
1234
(or your personal code), followed by
#
, a long beep will be emitted and the STATUS LED will flash.
- Enter again
1234
(or your personal code) and select the area to be deleted. Push key 1 for area 1, key 2 for
area 2 and key 3 for PANIC area, a long beep will be emitted.
