·
If you choose the simultaneous water inlet
and outlet mode, the water change will not end
immediately when the water change amount
reaches the predetermined value. The system
will automatically adjust the water level to the
middle of the MID and LOW sensing points, and
then return to the standby interface.
1
2
3
·
During calibration, as long as the inlet and outlet
pumps are working properly and the water level is
not lower than the low induction line or higher
than the high induction line, it is normal.
·
The larger the fish tank, the closer the speed of
water entering and exiting, the
longer it takes,
even more than half an hour.
·
When the water level is too high (higher than HIG),
or low (below Low), the water change cannot be
started.
The amount of water used in the water level
adjustment and pump check process is not included
in the total water exchange volumeexchange.
4
·
After the water change is started, the water
will be automatically drained below the LOW
sensor line, and then a small amount of water
will be introduced until the water level is
normal. This process is used to determine that
the water inlet and outlet channels are normal.
Calibration
related
Pump
check
Level
adjustment
Instructions for use [related to A.W.C.]
Operational
restrictions
1
2
·
ATO indicator: always on when running, off
when standby
· Pause indicator: always on when standby,
flashing when paused
· AWC indicator: off when standby, always on
when changing water
·
The water level indicator flashes for 2
seconds after it is on for 2 seconds, please
change the installation position to avoid
direct sunlight.
· If the indicator light is on and the water level
is low, realign the inner and outer modules.
Running
instructions
Instructions for use [indicator]
Water level
indication
1. Press and hold the ATO and AWC buttons
simultaneously for 5 seconds and then
release the buttons.
1
2
Child lock
2. The indicators under all keys are off, and
clicking any button will not trigger the
corresponding function (but there will be a
key feedback sound and light.
Child lock
Child lock and other functions
3
3. Press and hold the ATO and AWC buttons
simultaneously for 5 seconds to release the
lock state.
Child lock
15 16
