Installation and A.W.C.function
1
1
2
1
5
6
Precautions
·
AWC introduction: Automatic replacement of
old and new water for the fish tank according to
the specified water exchange volume and
·
If
you do not specify an automatic water change
cycle, you can only start a water change task by
manually clicking the AWC button.
·
If the water level drops quickly after
exceeding the HIGH level line, there may be
water droplets remaining on the sensor
head, which may cause a false alarm that the
water level is too high. You can take out the
internal module and shake it gently to
remove the water droplets.
·
One-key top-up: If the water level is lower
than the LOW level when the A.T.O.
function is paused, short press the A.T.O.
button to start one-key top-up.
·
If you do not specify an automatic water change
cycle, you can only start a water change task by
manually clicking the AWC button.
· Clicking any button during the water change will
stop the water change.
1. Perform automatic calibration.
2.Test the water change function
3.Set the water exchange volume.
5. Other setting items (optional).
4.Set the water change interval
1
2
3
1
·
The A.T.O. function is automatically suspended
during the automatic water change.
· Briefly press the A.T.O. button to manually
perform a quantitative water addition.
·
You can use the setting function to reset the
water volume for a single water fill action.
Advanced
A
.
T
.
O
.
2
·
Pause A.T.O .: If you do not want the A.T.O.
function to be performed, press the Pause
button briefly; press the button again to
resume the A.T.O. function.
Interface
introduction
2
·
The significance of automatic calibration:
Because the size of the fish tank is different for
each user, the calibration function allows the
equipment to scan and calculate the fish tank in
order to accurately provide automatic water
change services.
Features
A
.
T
.
O
.
Features
A
.
T
.
O
.
Advanced
A
.
T
.
O
.
Features
A
.
W
.
C
.
Features
A
.
W
.
C
.
Steps for usage
Calibration
A.T.O. introduction:
It can automatically maintain
the water level between the MID and LOW water
level to prevent the situation of low water level
caused by evaplinesoration.
· With temperature function on standby:
Time
and temperature are displayed alternately.
·
During standby:
The current time is displayed
and can be changed in settings.
· When adding water:
Countdown. Water will
not stop until the countdown ends.
