·
Project positioning:
F3S2-HXXX
· The maximum temperature that can be
detected can be set. If the temperature is higher
than this, the system will beep after 5 minutes.
Automatically dismiss the alarm when the
temperature returns to normal
.
5
1
2
· Select this function when the water level is lower
than the Low water level, the system will
automatically rise water to the LOW water level,
and use this time as the timeout protection time
of the one-click full function of daily operation.
·
Project location:
F2S4
· You can set the maximum running protection
time for one-key full function.
· Plugging or unplugging the temperature probe
under power may cause equipment damage.
·
The temperature probe is not hot-swappable
· Temperature probe must be inserted when
power is off
.
3
· Option On: Enable temperature monitoring
· Option Off: Disable temperature
monitoring
·
Project location:
F3S1-XX
· Default: Off
4
Low limit
·
Project location:
F3S3-HXXX
· It can set the minimum temperature that can
be detected. Below this temperature, the
system will beep after 5 minutes.
· The alarm will be automatically cancelled
when the temperature returns to normal.
One-click
top up
protection
Function switch
High limit
Advanced settings (optional) [S2 -TEMP.]
13
Precautions
1
2
3
4
· Option Off: Disable beep alert on anomalies
·
Project positioning:
F4S2
· Option On: Beep alert when abnormal
· Default: Off
· Set the correct current time for the system,
so that the automatic water change task can
be performed accurately at the time you set.
·
Project location:
F4S1
·
Project location:
F4S3-XX.X
· The temperature compensation value can be
set. The system will superimpose this value
on the detection result as the final
temperature detection result.
5
· Selecting this item will restore the system to
factory settings. The effect is equivalent to pressing
3 buttons at the same time to restore the factory
settings.
·
Project location:
F4S4
Beep settings
·
Project location:
F4S3-XX.X-X
·
Option C: Use ° C as the temperature unit
·
Option F: Use ° F as the temperature unit
· Default value: ° F
Advanced settings (optional) [S4 -SYSTEM]
Temperature
compensation
Temperature
unit
Restore
Factory
System time
14