7
1
2
3
7
·
Click the "AWC" button to change the water
once with the default settings:
Water change: 10 liters.
Operating mode: Simultaneous
8. Calibration will be completed automatically
and return to the standby interface.
5. After the container is full, press the Set
button again.
6. Enter the approximate capacity of the
container in ML.
· The value on the screen represents the
amount of water that has been changed. The
water change task is ended when the set
amount of water is reached.
3
4
1. Press and hold the Set button for 5 seconds to
enter the setting mode, and F1 is displayed on
the screen.
2. Press the Set button again to display F1S1.
5
3. Prepare a container under the water outlet
of the water inlet pipe.
4. Press the Set button again, and the system
starts to pour water into the container.
4
·
If the water change is successfully completed,
you can further personalize the automatic water
change according to the following instructions.
Setup
calibration
6
7. Press the SET button again, the system
starts to automatically enter and exit the
water, and the progress is displayed on the
screen as a percentage.
Test run
·
Click any button during the water change
process to terminate the water change task.
8
Test run
Setup
calibration
Setup
calibration
Setup
calibration
Setup
calibration
Test run
Test run
Test run
·
During calibration, the system will add water
first, then drain water, and finally enter and
exit the water for a period of time. If you find
that neither water is added nor drained,
please check the water source and water inlet
and outlet equipment.
8
Notice
